Understand the Forming Limit Diagram in PAM-STAMP 2025
The first FLD can look like someone scattered points across a graph and left you to interpret them. The useful part is that those points belong to locations on the…
pam stamp
Read Thickness and Thinning Results in PAM-STAMP 2025
Suppose a sheet starts at 1.00 mm and becomes 0.80 mm thick at one location. It has lost 0.20 mm, which is 20% of its original thickness. That is a…
View Results and Set Contour Legends in PAM-STAMP 2025
The run is finished and the blank is covered in colours. It looks interesting, but red by itself tells us very little. We need to know which result is displayed…
Define Trimming in PAM-STAMP 2025
After forming, we may need to remove part of the sheet. That is where trimming comes in. The curve describes the cut, but we also need to tell PAMSTAMP which…
Run and Monitor a Simulation in PAM-STAMP 2025
Now we can run it. Open Start a Computation through the workflow controls and look at the selected action before confirming. Why am I pointing this out? Because writing an…